This is the file provided by Wanhao for the second batch of units that are shipped in two parts and need some assembly.
This is the file provided by Wanhao on the SD card shipped with the initial units. If someone has any other versions let us know.
This is the file provided by Wanhao on the SD card shipped with the initial units. If someone has any other versions let us know.
These are a list of tool I would recommend to any person that owns a 3d printer. They come in handy all the time when doing mods, repairs or just regular maintenance.
The set screws the rod holders use are an EXTREMELY common size 1.5mm. For sure, you will want to have more than one of these long term.
Also, a ball driver for the M3 and M4 is pretty much the next must have if you get into this hobby.
Here's a list of my favorites L allen wrench set with ball ends on one end. L Wrench Set Ball Ends $10 well spent. These are harder and stronger than most- less likely to strip out and worth every penny
Ball driver set. These make your life a dream when they can be used. I am lost and usually angry when I don't have these handy. Ball Driver Set $16 but trust me, the ease of use factor- you'll NEVER go back or regret these.
Not so much a big deal for this printer since all the factory screws tighten into threaded metal. But long term and even for the mod of using locking M3 nuts on the long Bed leveling screws, this is another must have. M3 nut driver with massive recess for long screws. Again, just doing the bed mod- this pays for itself in one usage. M3 Nut Driver $6 bit again, in the hobby, there are a million M3 nuts, and this is one of my most used tools.
GOOD side cutters. There is a difference, this is one of the best. Side cutters $10, but again, you'll go through 3 pairs of cheap ones that are never as good as this one.