DupI3
Known EEPROM settings:
!!!!!!Firmware Configuration Options:
Firmware
DupI3.Firmware History
Hide minor edits - Show changes to output
Changed line 28 from:
[+Note: The code compiles with basic options takes up 93% or 122K of the 131K of program space.+]
to:
[+Note: The code compiles with basic options and auto bed leveling enabled but without the z probe enabled takes up 93% or 122K of the 131K of program space.+]
Added lines 26-28:
* Processor selection is Sanguino 1284p 16MHZ
[+Note: The code compiles with basic options takes up 93% or 122K of the 131K of program space.+]
[+Note: The code compiles with basic options takes up 93% or 122K of the 131K of program space.+]
Changed line 12 from:
* Z Max Steps/mm '''25''
to:
* Z Max Steps/mm '''25'''
Changed line 14 from:
* EXT1 Steps ~''105'''
to:
* EXT1 Steps ~'''105'''
Changed lines 2-3 from:
to:
[+Information gathered on the correct EEPROM settings for use with Repetier firmware and the compile options when compiling from source. We have successfully compiled the latest firmware v0.92.3 from source after making some modifications to support the LCD pins and board features.+]
----
!!!!!!Known EEPROM settings:
----
!!!!!!Known EEPROM settings:
Changed lines 19-21 from:
Firmware Configuration Options:
to:
!!!!!!Firmware Configuration Options:
Deleted line 24:
Added lines 19-20:
* Motherboard type is '''63''' for Melzi
* FEATURE_CONTROLLER is '''11''' for Reprap full graphics LCD controller
* FEATURE_CONTROLLER is '''11''' for Reprap full graphics LCD controller
Added lines 1-19:
!!!Duplicator I3 Firmware Information
Known EEPROM settings:
* X Steps/mm '''80'''
* Y Steps/mm '''80'''
* X Homing Speed '''40'''
* Y Homing Speed '''40'''
* Z Steps/mm '''400'''
* Z Max Steps/mm '''25''
* Z Homing Speed '''15'''
* EXT1 Steps ~''105'''
* EXT1 Management Type: '''3''' for Deadtime
* EXT1 PID Gain (if using type 3): '''7'''
* HB Management Type: '''3''' for Deadtime
* HB PID Gain (if using type 3): '''7'''
Firmware Configuration Options:
* All homing is to MIN Endstops
Known EEPROM settings:
* X Steps/mm '''80'''
* Y Steps/mm '''80'''
* X Homing Speed '''40'''
* Y Homing Speed '''40'''
* Z Steps/mm '''400'''
* Z Max Steps/mm '''25''
* Z Homing Speed '''15'''
* EXT1 Steps ~''105'''
* EXT1 Management Type: '''3''' for Deadtime
* EXT1 PID Gain (if using type 3): '''7'''
* HB Management Type: '''3''' for Deadtime
* HB PID Gain (if using type 3): '''7'''
Firmware Configuration Options:
* All homing is to MIN Endstops